Spring Plowing Production Agricultural Machinery Maintenance Technical Guide (IV)-Corn Sowing.
(IV)
1. Read the instruction manual before operation, pay attention to warning signs, safe production, and prohibit illegal operation.
2. Adjustment of row spacing and wheel spacing. Pay attention to the tractor wheel spacing and sowing row spacing match, to meet the requirements of various sowing patterns.
3, the determination of sowing density. According to corn varieties, soil (black soil, loess, sandy soil) to determine the sowing density; According to the amount of fertilizer and fertility to determine the sowing density; But also according to the regional rainfall, soil water storage effect, terrain, water content to determine the planting density, do not be too dense.
4, sowing operation speed. The faster the no-tillage sowing speed or the lower the speed, the quality of the operation cannot be guaranteed. The best operation speed of no-tillage sowing is 8 km/h, the maximum speed cannot exceed 10km per hour, and the low-speed operation cannot be less than 3 krn/h.
5. Rack height adjustment. Before the seeder is formally operated in the field, the height of the beam frame of the seeder should be adjusted first, so as to leave a certain amount of profiling on the profiling mechanism on the seeding monomer, and avoid the damage of parts or the depth of seeding caused by the weight of the whole machine. The height of the supporting wheel is adjusted by rotating the supporting wheel adjusting screw, so that the sowing frame is raised or lowered, and the fertilization depth of the fertilization parts is ensured to be suitable.
6, sowing depth adjustment. Adjust the depth limit pointer handle on each seeding monomer, and make the depth limit pointer on each seeding monomer at the same scale position during operation to ensure the consistent seeding depth of the whole machine. However, in the actual operation of sowing operation, limited by different soil preparation conditions and soil environment, the actual sowing depth should be measured after sowing depth adjustment. Once the indicated sowing depth is inconsistent with the actual sowing depth, secondary fine adjustment should be carried out to achieve the effect of consistent sowing depth.
7, the adjustment of sowing spacing. The adjustment of sowing spacing is to adjust the transmission system of the planter. Most of the transmission systems of the planter are completed by chain transmission. The corresponding adjustment can be made according to the sowing table in the instruction manual, and the corresponding chain wheel is hooked and tensioned.
8, the amount of fertilizer adjustment. Crop variety, number of seedlings per mu (ridge spacing and plant spacing) and soil fertility determine the amount of fertilizer applied per mu. According to the requirements of the amount of fertilizer applied, the amount of fertilizer discharged by the fertilizer discharging device shall be determined based on 10 turns of the support wheel, and then the amount of fertilizer discharged per mu (slip rate shall be calculated at 10%) shall be calculated until the amount of fertilizer discharged per mu is adjusted.
9, wide narrow row no-till sowing considerations. The tractor shall be aligned, and the sowing width shall be consistent alternately, the ridge spacing and wheel spacing shall be matched, and the sowing density (plant spacing) shall be appropriate and shall not be encrypted. Row spacing shall be determined according to the harvesting method and original ridge spacing.
10, the original ridge no-tillage sowing matters needing attention. The ridge distance is matched with the wheel distance. The tire walks in the ridge and furrow. When the ridge is too high, it needs to be flattened. If there is straw or root stubble is too thick, consider shallow rotation on the ridge.

