Created on:2023-11-24

Frequent Rainfall

Frequent Rainfall


1. Drainage and scattering of soil moisture: For plots with accumulated water in the field, especially in areas with sticky soil, the accumulated water is drained to low-lying places by digging ditches, dredging three ditches inside and outside the field block, increasing the density of field ditches and other measures, and forced drainage is carried out by pumping equipment such as water pumps to drain accumulated water in the field as early as possible and reduce the soaking time of plots. No.plots with accumulated water but excessive soil moisture, the accumulated water in the plough layer can be drained by digging deep trenches, and the soil moisture can be loosened deeply if conditions permit.

2. Straw treatment: for plots with soil moisture content suitable for unit operation, normal straw returning operation shall be carried out. When the combine harvester is selected to be equipped with a straw chopping and throwing device, the height of straw stubble shall be ensured to be ≤ 80mm, which is conducive to subsequent straw rotary tillage or deep turning and stubble returning. When straw returning machine is selected for straw returning, the crushing length of corn straw shall be ≤ 100mm and the uniformity of straw throwing shall be ≥ 80%, so as to avoid too long straw or accumulation, affecting crop emergence and growth. For plots with high soil moisture content, it is not advisable to carry out straw crushing operation too early. Straw leaving the field can be used to create conditions for soil moisture scattering and subsequent mechanical soil preparation operation. The crushed straw shall be treated to expose the surface of the seeding belt, which is conducive to water evaporation. For plots with accumulated water in the field, machines and tools should not enter the field too early for straw crushing operation to avoid soil consolidation affecting sowing. After ditching and drainage, the plot can be dried, then carry out the operation of straw returning machine.

3, land tillage: based on the actual soil moisture, reasonable pre-sowing tillage. Generally, the soil moisture content of tillage and soil preparation should be 18% ~ 22%. For plots with soil moisture content suitable for unit operation, normal tillage before sowing can be carried out. Rotary tillage operation, rotary tillage depth should be determined according to the plot soil moisture and local agronomic requirements, generally 12~16cm; for the problem of large soil moisture, through deep turning on the soil for vertical drying, when the moisture is suitable to rake the whole land, can also use vertical drive rake and other active raking machinery, can appropriately reduce the quality of the operation, in order to grab the purpose of tillage; for the plots with accumulated water in the field, it is not suitable to carry out tillage and soil preparation immediately. The plots can be properly dried and tilled before sowing when the soil moisture is suitable.

4. Timely sowing: for the plots with moisture content suitable for unit operation, the plots with suitable sowing date after tillage can be sowed normally. When sowing, the appropriate sowing rate and sowing depth should be determined according to the sowing date to ensure the smooth emergence of winter wheat and reduce the emergence time of winter wheat. For plots exceeding the local suitable sowing date, attention should be paid to replacing winter wheat varieties suitable for late sowing and early maturing with coating or chemical seed dressing, and the sowing rate should be increased appropriately, promote root development and tillering growth of late-sowing winter wheat; For plots with too much soil moisture and short-term tillage and soil preparation, wheat no-tillage planter with good blocking resistance can be used for no-tillage sowing of hard stubble. Due to high soil moisture content, blockage may be more likely to occur. Attention should be paid to reducing the forward speed during operation and timely removal of blockage. For straw directly returning to the field, double operation machine such as strip rotary tillage is adopted, complete the tasks of soil preparation, fertilization, sowing and suppression at one time, reduce the number of machines and tools entering the ground, shorten the operation time, reduce the rolling of soil and play a role in grabbing agricultural time.


维修保养

Created on:2023-11-24

Frequent Rainfall

Frequent Rainfall


1. Drainage and scattering of soil moisture: For plots with accumulated water in the field, especially in areas with sticky soil, the accumulated water is drained to low-lying places by digging ditches, dredging three ditches inside and outside the field block, increasing the density of field ditches and other measures, and forced drainage is carried out by pumping equipment such as water pumps to drain accumulated water in the field as early as possible and reduce the soaking time of plots. No.plots with accumulated water but excessive soil moisture, the accumulated water in the plough layer can be drained by digging deep trenches, and the soil moisture can be loosened deeply if conditions permit.

2. Straw treatment: for plots with soil moisture content suitable for unit operation, normal straw returning operation shall be carried out. When the combine harvester is selected to be equipped with a straw chopping and throwing device, the height of straw stubble shall be ensured to be ≤ 80mm, which is conducive to subsequent straw rotary tillage or deep turning and stubble returning. When straw returning machine is selected for straw returning, the crushing length of corn straw shall be ≤ 100mm and the uniformity of straw throwing shall be ≥ 80%, so as to avoid too long straw or accumulation, affecting crop emergence and growth. For plots with high soil moisture content, it is not advisable to carry out straw crushing operation too early. Straw leaving the field can be used to create conditions for soil moisture scattering and subsequent mechanical soil preparation operation. The crushed straw shall be treated to expose the surface of the seeding belt, which is conducive to water evaporation. For plots with accumulated water in the field, machines and tools should not enter the field too early for straw crushing operation to avoid soil consolidation affecting sowing. After ditching and drainage, the plot can be dried, then carry out the operation of straw returning machine.

3, land tillage: based on the actual soil moisture, reasonable pre-sowing tillage. Generally, the soil moisture content of tillage and soil preparation should be 18% ~ 22%. For plots with soil moisture content suitable for unit operation, normal tillage before sowing can be carried out. Rotary tillage operation, rotary tillage depth should be determined according to the plot soil moisture and local agronomic requirements, generally 12~16cm; for the problem of large soil moisture, through deep turning on the soil for vertical drying, when the moisture is suitable to rake the whole land, can also use vertical drive rake and other active raking machinery, can appropriately reduce the quality of the operation, in order to grab the purpose of tillage; for the plots with accumulated water in the field, it is not suitable to carry out tillage and soil preparation immediately. The plots can be properly dried and tilled before sowing when the soil moisture is suitable.

4. Timely sowing: for the plots with moisture content suitable for unit operation, the plots with suitable sowing date after tillage can be sowed normally. When sowing, the appropriate sowing rate and sowing depth should be determined according to the sowing date to ensure the smooth emergence of winter wheat and reduce the emergence time of winter wheat. For plots exceeding the local suitable sowing date, attention should be paid to replacing winter wheat varieties suitable for late sowing and early maturing with coating or chemical seed dressing, and the sowing rate should be increased appropriately, promote root development and tillering growth of late-sowing winter wheat; For plots with too much soil moisture and short-term tillage and soil preparation, wheat no-tillage planter with good blocking resistance can be used for no-tillage sowing of hard stubble. Due to high soil moisture content, blockage may be more likely to occur. Attention should be paid to reducing the forward speed during operation and timely removal of blockage. For straw directly returning to the field, double operation machine such as strip rotary tillage is adopted, complete the tasks of soil preparation, fertilization, sowing and suppression at one time, reduce the number of machines and tools entering the ground, shorten the operation time, reduce the rolling of soil and play a role in grabbing agricultural time.